Networking vserver guests RHEL

From Linux-VServer

Revision as of 03:21, 7 May 2008 by (Talk)

Jump to: navigation, search


Public IP Space

Chose a private IP range

Private IP Range:
Host Private IP:
Guest Private IP:


In a RHEL based system many configurations are stored in /etc/sysconfig. The network settings are /etc/sysconfig/network-scripts.

cp /etc/sysconfig/network-scripts/ifcfg-eth0 /etc/sysconfig/network-scripts/ifcfg-eth0:1
vi  /etc/sysconfig/network-scripts/ifcfg-eth0:1

This IP address will now start at boot up.

ifup eth0:1

Assuming your vserver is test01

echo "eth0:1" > /etc/vservers/test01/interfaces/0/dev/
echo "" > /etc/vservers/test01/interfaces/0/ip
echo "" > /etc/vservers/test01/interfaces/0/mask

You can use iptables to make youre system act as a router.

iptables -t nat -A POSTROUTING -s \ 
  -d ! -j SNAT --to-source $EXTIP

Now your guest should have outbound connectivity.

[root@34 ~]# vserver test01 enter
bash-3.1# ifconfig 
eth0      Link encap:Ethernet  HWaddr 00:0E:0C:69:ED:E0  
          inet addr:  Bcast:  Mask:
bash-3.1# ping
PING ( 56(84) bytes of data.
64 bytes from ( icmp_seq=1 ttl=244 time=22.3 ms
64 bytes from ( icmp_seq=2 ttl=244 time=22.5 ms

Inbound Connections and NAT

Now we have to establish inbound connectivity. This can be done with Network Address Translation. We can expose the SSH service through NAT.>
Personal tools