Networking vserver guests
From Linux-VServer
Setting up network access to and from your vserver guests.
Contents |
Introduction
Lets imagine, you have only one external IP -- $EXTIP.
You want to have several vservers running without worrying about port overlapping.
Example:
Two vservers run a default webserver, running on port 80. If each "guest" vserver shares an IP with the host, then the two webservers will conflict.
One solution is:
- All vservers are contained in a "virtual lan", say 192.168.1.x
- Each vserver has its own IP
- Control port forwarding on "parent" host. That is, run a router.
Configuration
Host
Optional: Load 'dummy' device(s)
Why?
This driver allows you to associate vServer guests with a virtual network device rather than the host's real network interface, which functions to hide packet counters from vServer guests. There is no other use for this step, so feel free to skip it if you are not worried about sharing packet counters. Packet counts may be useful to an attacker with control of a vServer guest who wishes to perform side-channel attacks during cryptanalysis, or network traffic analysis against your host or other vServer guests. If you did not understand the last sentence and your installation is not particularly security sensitive, then the chances that you will encounter a skilled attacker are slim to none and you should feel free to skip this section.
Process
First you need to load the dummy interface driver
# modprobe dummy
To have it automatically loaded on startup, add "loopback" to /etc/modules
Set up dummy0 interface on the parent host
# /etc/network/interfaces on a Debian box,
# configure on other distros with your preferred way
auto dummy0
iface dummy0 inet static
address 192.168.1.250
netmask 255.255.255.0
Guests
Set up each guest vserver:
cd /etc/vservers/$VSERVER/interfaces/0 echo dummy0 > dev echo 192.168.1.1 > ip echo 1 > name echo 24 > prefix
Consider using a value of name equal to the last digit of the IP for easy separation.
Host as router
Configure the host to act as a router.
For internal packets going outside, pretend each packet came from our external IP (put it in one line without backslash):
# iptables -t nat -A POSTROUTING -s 192.168.1.0/24 \ -d ! 192.168.1.0/24 -j SNAT --to-source $EXTIP
For each service that runs on a vserver, map it to an external port. Vserver local address $VHOST and port $INTPORT you select one external port $EXTPORT and run the following (put it in one line without backslash):
# iptables -t nat -A PREROUTING -s ! 192.168.1.0/24 \ -m tcp -p tcp --dport $EXTPORT -j DNAT --to-destination $VHOST:$INTPORT
That's all!
Verifying
Try ping pool.ntp.org from your vserver -- it should ping fine.
Try to connect to your $EXTIP:$EXTPORT (from another external host) -- you will successfully connect to service running on a guest vserver.
