Difference between revisions of "Networking vserver guests"

Revision as of 23:15, 1 October 2009

Setting up network access to and from your vserver guests.

Introduction

Lets imagine, you have only one external IP -- $EXTIP.

You want to have several vservers running without worrying about port overlapping.

Example:

Two vservers run a default webserver, running on port 80. If each "guest" vserver shares an IP with the host, then the two webservers will conflict.

One solution is:

• All vservers are contained in a "virtual lan", say 192.168.1.x
• Each vserver has its own IP
• Control port forwarding on "parent" host. That is, run a router.

Configuration

Host

First you need to load the dummy interface driver

# modprobe dummy

To have it automatically loaded on startup, add "loopback" to /etc/modules

Set up dummy0 interface on the parent host

# /etc/network/interfaces on a Debian box, 
# configure on other distros with your preferred way
auto dummy0
iface dummy0 inet static
    address 192.168.1.250
    netmask 255.255.255.0

Guests

Set up each guest vserver:

cd /etc/vservers/$VSERVER/interfaces/0
echo dummy0 > dev
echo 192.168.1.1 > ip
echo 1 > name
echo 24 > prefix

Consider using a value of name equal to the last digit of the IP for easy separation.

Host as router

Configure the host to act as a router.

Enable IP forwarding:

# echo 1 > /proc/sys/net/ipv4/ip_forward

For internal packets going outside, pretend each packet came from our external IP (put it in one line without backslash):

# iptables -t nat -A POSTROUTING -s 192.168.1.0/24 \ 
  -d ! 192.168.1.0/24 -j SNAT --to-source $EXTIP

For each service that runs on a vserver, map it to an external port. Vserver local address $VHOST and port $INTPORT you select one external port $EXTPORT and run the following (put it in one line without backslash):

# iptables -t nat -A PREROUTING -s ! 192.168.1.0/24 \
  -m tcp -p tcp --dport $EXTPORT 
  -j DNAT --to-destination $VHOST:$INTPORT

That's all!

Verifying

Try ping pool.ntp.org from your vserver -- it should ping fine.

Try to connect to your $EXTIP:$EXTPORT (from another external host) -- you will successfully connect to service running on a guest vserver.

See also

• FAQ on private networking
• Permit guest sshd to bind to its IP address's port 22
• Networking_vserver_guests_RHEL