Difference between revisions of "IPv6"
From Linux-VServer
| Line 4: | Line 4: | ||
| − | Starting with linux-vserver-2.3 IPv6 support is included in the main source code. No need to apply any extra patches. You will need to have util-vserver 0.30.214 or newer if you are using the 2.3+ patches | + | Starting with linux-vserver-2.3 IPv6 support is included in the main source code. No need to apply any extra patches. You will need to have util-vserver 0.30.214 or newer if you are using the 2.3+ patches. |
==Dual-Stack== | ==Dual-Stack== | ||
If you want both IPv6 and IPv4 addresses, just use IPv6 on one interface and create another interface with IPv4. | If you want both IPv6 and IPv4 addresses, just use IPv6 on one interface and create another interface with IPv4. | ||
Revision as of 14:58, 15 July 2010
At the time of this writing, IPv6 support in guests requires you to apply an additional patch on top of the Linux-VServer patch. The IPv6 patch can be fetched from the official source: Bruno Prémont's IPv6 patches, and sometimes rediffs against later kernels are available from my patch directory.
To use the patch, you need util-vserver 0.30.212 or newer. These versions support IPv6 natively, so you just need to put the address in /etc/vservers/<guest>/interfaces/X/ip and start the guest to get it an IPv6 address.
Starting with linux-vserver-2.3 IPv6 support is included in the main source code. No need to apply any extra patches. You will need to have util-vserver 0.30.214 or newer if you are using the 2.3+ patches.
Dual-Stack
If you want both IPv6 and IPv4 addresses, just use IPv6 on one interface and create another interface with IPv4.
